Welcome to Sky Soaring › Forums › Restricted content › December 11th work party
- This topic has 4 replies, 3 voices, and was last updated 2 years, 10 months ago by John Phelan.
-
AuthorPosts
-
-
Saturday, December 11th, 2021 at 4:58 pm #11439John LincolnParticipant
I’m giving a shout out and THANK YOU to Steve and Petr for work on the Krosno nose and skid, John Osborn and Laurentiu for continuing the repair of the 1-34 gear, Pete and Nick for work on the 1-26, Don and Nick for work on Pumpkin and Jim for continuing to seal holes at the top of the west hangar walls at the roof line. Jim is really getting up there. Greg also was out helping. Our leader John DeRosa came out for a few minutes just to see how all was going. Again thanks to all who were out today.
One more item that needs attention as pointed out by Greg is the tankless water heater is again leaking. It may be time to replace that particular unit with a new one. Petr knows someone who does plumbing so that may be a consideration.
John Lincoln
-
Saturday, December 11th, 2021 at 5:14 pm #11440John DeRosaParticipant
About the tankless water heater I installed it. No need to pay for a plumber. I will begin shopping.
Best Regards,
John H DeRosa -
Saturday, December 11th, 2021 at 5:27 pm #11441John PhelanParticipant
Can the leak be resoldered?
Best Regards,
John F. Phelan
From: Sky Soaring <webmaster@skysoaring.com>
Sent: Saturday, December 11, 2021 17:17
To: phelanjf@gmail.com
Subject: [Sky Soaring] General Discussion, Reply To: December 11th work party -
Saturday, December 11th, 2021 at 6:07 pm #11442John LincolnParticipant
When it comes to plumbing and plumbing repair I almost always yield to the pros or to those who want to attempt a repair. I learned long ago how to make leaks and am pretty successful at it. SSI already has a leak (or two) so my particular specialty is no longer needed. John Lincoln
-
Saturday, December 11th, 2021 at 6:25 pm #11444John PhelanParticipant
Worth a try before we sink $$ into a new unit. If it is only a leaky solder joint, it should easily be able to be fixed by re-sweating the junction. Sounds like a good 10 minute project on January 1st before the chili kicks in.
Best Regards,
John F. Phelan
From: Sky Soaring <webmaster@skysoaring.com>
Sent: Saturday, December 11, 2021 18:11
To: phelanjf@gmail.com
Subject: [Sky Soaring] General Discussion, Reply To: December 11th work party
-
-
AuthorPosts
- The forum ‘Restricted content’ is closed to new topics and replies.